Samco
Roll Former with quick-change tooling and
auto gauging capabilities
This machine has reduced our set up time from six
hours to five minutes and increased our speeds from
53 feet a minute to 200 feet per minute. This is
the most technically advanced mill available today.
Rafted
Yoder Roll Forming Line with eight stands
This machine will cut our set up time from ten
hours to one hour. A Rafted mill allows you to
leave the tooling on the stands and pull an entire
series of stands off at one time never changing
the tooling.
Four
Programmable Length Control Units
These units have allowed us to increase our line
speeds from 60 feet per minute up to 200 feet
per minute and increase our length control tolerances
from plus or minus 1/32” to plus
or minus 1/64th.
Two
Programmable Coe Servo Feeds
These Servo Feeds have allowed us to increase our
feed speed from 50 feet per minute to 200 feet
per minute with increased accuracy.
250
Ton Bliss Straight Side Press
This press was located at the entrance to our 3” Yoder
line and allows us to pre-punch larger patterns
and heavier gauges than in the past.
Panasonic
Six Axis Robotic Welder
This robotic work cell has allowed us to increase
our welding capacity by over three times what
was possible with manual welding. Because of
the success of this robotic work cell, we are
currently in the process of purchasing another
one.
New
Conveyer System for Powder Line
This new conveyer system has allowed us to run
heavier sections through our powder line giving
us more capabilities for more weight from before.
|
